One of the challenges of bending is preventing the profile from having bending marks, such as scratches and abrasions on the surface areas.
Especially of profiles made of:
often show lines in the contact areas between sheet metal and die. This is the consequence of friction occurring when bending sheet metal with dies with small radius on the V opening.
In order to prevent this marking, the following solutions are possible:
The following options are available to prevent bending marks on the surfaces:
The alternative to these options mentioned above,
is a modification of the dies:
This solution is available on stock for some of our T-Dies under the Article No.: TR
There are no items in your shopping cart!
Prevention of Bending Marks by:
© Copyright - ROLLERI BALTIC, Atstovybė UAB "TTMT“ - R. Kalantos g. 161 - LT-52315 Kaunas – Lietuva - Phone: +370 37 32 84 87 - Email: